Download to your hard drive the proper Cisco 7921 firmware installer for your Cisco Unified CallManager version as shown in Table 1. Please note that different versions of the. Download USB-Install-7921.1-0-1-Readme.pdf and follow the instructions to install the Cisco Unified Wireless IP Phone 7921G USB driver. Download to your hard drive the proper Cisco 7921 firmware installer for your Cisco Unified Communications Manager version, as shown in Table 1. Follow the instructions below to upgrade your phone firmware using a USB. And follow them to install the Cisco Unified Wireless IP Phone 7921G/7925G USB driver.

• • • Introduction How to install PEAP Certificate for 7921 via USB interface Solution Procedure to install PEAP Certificate for 7921 via USB interface on phone via PC/Laptop Configuring the USB LAN on the PC To configure the USB LAN connection on your PC, follow these steps: 1. To setup the USB LAN connection, do one of the following: • For Windows XP—Click Start >Control Panel >Network Connections. • For Windows 2000—Click Start >Settings >Control Panel >Network and Dial Up Connections. Locate and double-click the new LAN connection to open the Local Area Connection Status window, then click Properties. Scroll to the Internet Protocol (TCP/IP) component and click Properties. In the Internet Protocol (TCP/IP) Properties window, choose Use the following IP address: 5.

In the IP address field, enter a static IP address for the PC: 192.168.1. Odin3 Free Download For Android. (1-254 -except 100), for example: 192.168.1.11 Note • By default, the Cisco Unified Wireless IP Phone 7921G is configured with 192.168.1.100 so you cannot use this IP address for the PC. • Make sure to use an IP address that is not in use on any other interface on the PC. 6 Enter the subnet mask: 255.255.255.0 7 Click OK to make the changes.

Accessing the Phone Web Page After setting up the USB interface on the PC, you are ready to use the USB cable connection to the phone. License Key Generator Algorithm. To access the phone web page, follow these steps: 1 Open a Windows browser. 2 In the address field, enter to locate the wireless IP phone web page. Note Default credentials for login are admin/Cisco to access the phone configuration page. Note When the Security Alert dialog box displays a notice to accept the Trust Certificate, click Yes or Always to accept the application.

3 Use the hyperlinks in the left column of the web page to configure settings for the phones. For information, see these sections 4 After entering the new settings, disconnect the USB cable from the phone. The settings are active immediately.

5 Check that the phone can access the network successfully. Installing the Authentication Server Root Certificate (for PEAP) The Authentication Server Root Certificate must be installed on the Cisco Unified Wireless IP Phone 7921G. To install the certificate, follow these steps: 1 Export the Authentication Server Root Certificate from the ACS. See Exporting Certificates from the ACS. 2 Go to the phone web page and choose Certificates. Check if the certificate is in format DER encoded binary X.509 (.CER) 3 Click Import next to the Authentication Server Root certificate.

4 Restart the phone. Exporting Certificates from the ACS Here is the procedure to export the certificate from ACS. Exporting Certificates from the ACS Server Using Internet Explorer Use this method for exporting the CA certificate from the ACS server that uses a self-signed certificate.